Ranger IH User Guide:
Quick Start Guide:
Power On/Off Device:
- Click Center button 3 times
Switch From Wattage to Temp Mode:
- Click Center Button 2 times
Adjust Wattage & Temp:
- Use Left and Right Buttons to go up and down in wattage or temp.
Reset Sesh Counter :
- Hold Up and Down button together for 3 Seconds
Switch from C to F:
- Hold Center and Right button at the same time for 3 seconds.
Activating Heat:
Place your DynaVap Vap Cap into the glass bowl area. When heat is activated, you will see the change on your digital screen.
USB-C Charge: 2 Hour Charge is recommended before first use.
pass through charging is optional but not recommended.
PRO TIPS:
Wattage Mode: Try 45 Watts as a starting point!
Temp Mode: Set the Temp to 400F and ignore the click. Once the Vapcap hits temp pull out immediately for aggressive hits.
Warnings:
Low Battery - Charge your device.
High Temp - Allow device to cool before using
Heating Circuit Failure - Contact Customer Support
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article